Error after running /scripts/rhlupdate

[bsasninja]

After running /scripts/rhlupdate I got this error: Does it brake something? Is there a way to fix it?

CPAN.pm: Going to build G/GR/GRANTM/XML-Simple-2.15.tar.gz

Checking installed modules ...
=============================================================================

Fatal error: Your default XML parser (XML::SAX::PurePerl) is broken.

There are known bugs in the PurePerl parser included with version 0.13
and 0.14 of XML::SAX. The XML::Simple tests will fail with this parser.

One way to avoid the problem is to install XML::SAX::Expat - it will
install itself as the system default XML parser and then you will be able
to install XML::Simple successfully. XML::SAX::Expat is also much faster
than XML::SAX::PurePerl so you probably want it anyway.

=============================================================================
make: *** No targets specified and no makefile found. Stop.
/usr/bin/make -- NOT OK
Running make install
make had returned bad status, install seems impossible
perlmod--Install done

GD installed ok
root@server1 [~]#

Thanks

[bsasninja]

read fix below.

[bsasninja]

The solution is this, the problem was that I was confused with the XML::SAX files at Install a Perl Module cause there are a lot

One way to avoid the problem is to install XML::SAX::Expat - it will

install itself as the system default XML parser and then you will be able

to install XML::Simple successfully. XML::SAX::Expat is also much faster

than XML::SAX::PurePerl so you probably want it anyway.

[Bulent Tekcan]

Same problem here....

[10101]

The solution is this, the problem was that I was confused with the XML::SAX files at Install a Perl Module cause there are a lot

One way to avoid the problem is to install XML::SAX::Expat - it will

install itself as the system default XML parser and then you will be able

to install XML::Simple successfully. XML::SAX::Expat is also much faster

than XML::SAX::PurePerl so you probably want it anyway.

I ran that fix however it still brings the same message up if you run "Update System Software" from WHM.

[gahelm]

I am unable to install this. Could someone please outline the exact root command required to get this installed? Never mind, figured it out.... Just ran the install permod from within WHM then ran /scripts/upcp from ssh and all is well.

[flash7]

I am unable to install this. Could someone please outline the exact root command required to get this installed? Never mind, figured it out.... Just ran the install permod from within WHM then ran /scripts/upcp from ssh and all is well.

/scripts/perlinstaller XML::SAX::Expat
/scripts/upcp

[rogcan]

/scripts/perlinstaller XML::SAX::Expat
/scripts/upcp

Tried the above and it still reports the same error...

Anyone else with any ideas ??

[Bruceper]

I experienced the same issue. The above recommendation worked for me.

[tom@cheops.be]

Tried the above and it still reports the same error...

Anyone else with any ideas ??

Same problem here...

[xabungo]

This:

/scripts/perlinstaller XML::SAX::Expat
/scripts/upcp

Solve my problem too!
Regards,

[mystikzen]

Feedback :

/scripts/perlinstaller XML::SAX::Expat was successfull for me but XML::SAX::Expat didn't
become the default parser.
So I edited the file /usr/lib/perl5/site_perl/5.8.7/XML/SAX/ParserDetails.ini by replacing the first line with [XML::SAX::Expat]
upcp was successfull after that.