No, the update process will ensure the new version is correctly installed.would it be better to do a clean install when it goes to current
You may find this link helpful:Is there any ETA on 11.40 ver., update for the RELEASE TIER yet? Just would like to be prepared when it may come out.
Mike
1:1 NAT is only supported with clean/fresh installs of 11.40. We don't support any custom implementations that were done prior to 11.40. Please consult our documentation (1:1 NAT) for further information.Any issues with upgrading 11.38.2.7 (with actual 1:1 NAT customization) to 11.40.0.6?
The tier promotions are typically done on three week cycles. Hence you should see 11.40 appear in RELEASE late October, early November. The cycle is heavily influenced by discovered issues.cgimickalo said:no what I was referring to is an approx., timeframe when 11.40 version will be released to the RELEASE TIER. I see it's been released now for CURRENT TIERS.
So simple when I will upgrade to 11.40 new function, in that case 1:1 NAT support, will be not available but will just for clean/fresh installs?1:1 NAT is only supported with clean/fresh installs of 11.40. We don't support any custom implementations that were done prior to 11.40. Please consult our documentation (1:1 NAT) for further information.
Can you folks be a little more proactive about version histories, listing the improvements to the new EDGE/RELEASE TIER versions (11.40.0 (build 6)?Is there any ETA on 11.40 ver., update for the RELEASE TIER yet? Just would like to be prepared when it may come out.
Mike
Thank you for bring this to our attention. The change log will be updated today.You have still not updated the change log for 11.40.0 (build 6). You're still stuck at build 2.
Peace,
Gene