The Community Forums

Interact with an entire community of cPanel & WHM users!
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

eAccelerator: shmmax should be at least 2MB

Discussion in 'General Discussion' started by mrmister, Dec 29, 2010.

  1. mrmister

    mrmister Registered

    Dec 26, 2010
    Likes Received:
    Trophy Points:
    One of the heaviest pages on one of my sites started returning a blank page and when I ran "tail -f /usr/local/apache/logs/error_log" I had a lot of messages
    What's strange is that everything seems to be OK
    As soon as I did
    The page started working fine. Any ideas on what might be the issue?

    WHM 11.28.60
    CENTOS 5.5 i686 virtuozzo

    WITHOUT EAccelerator with page working:
    WITH EAccelerator with page not working:
    # df -h
    Filesystem Size Used Avail Use% Mounted on
    /dev/simfs 20G 6.6G 14G 34% /
    none 256M 4.0K 256M 1% /dev

    #1 mrmister, Dec 29, 2010
    Last edited: Dec 29, 2010
  2. cPanelDon

    cPanelDon cPanel Quality Assurance Analyst
    Staff Member

    Nov 5, 2008
    Likes Received:
    Trophy Points:
    Houston, Texas, U.S.A.
    cPanel Access Level:
    DataCenter Provider
    As the system is a Virtuozzo/OpenVZ-based virtual environment I would make sure the VPS container has sufficient resources allocated; you may use the following command to help check certain limitations imposed by the hardware node configuration of the virtual environment:
    # cat /proc/user_beancounters
    If providing the above output, I recommend to place it within the BBcode "CODE" tags for easier readability.

    The FAQ on the official eAccelerator web site includes VPS-specific information: FAQ – eAccelerator
    In case you have direct control over the VPS container configuration from the hardware node, I recommend referring to the following documentation about setting or changing the VPS resource limitations and related parameters:

    Related documentation: shmpages - UBC auxiliary parameters - OpenVZ Wiki

Share This Page