The Community Forums

Interact with an entire community of cPanel & WHM users!
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

eth0 setup

Discussion in 'Bind / DNS / Nameserver Issues' started by Mark_CFH, Nov 12, 2014.

  1. Mark_CFH

    Mark_CFH Well-Known Member

    Joined:
    Apr 2, 2013
    Messages:
    64
    Likes Received:
    0
    Trophy Points:
    6
    cPanel Access Level:
    Root Administrator
    We have some extra Ips, and we wanted to put some clients on one of the IPs. We set their domain to use the IP, however the site wont load or propagate to the IP. When we do a ping on the IP, it just comes up as request timed out. On WHM it shows the IP with eth0:cp30.

    Where or how do you set that up so that the IP works?
     
  2. mageshm

    mageshm Well-Known Member

    Joined:
    Apr 17, 2014
    Messages:
    90
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Chennai, INDIA
    cPanel Access Level:
    DataCenter Provider
    @Mark_CFH,

    If you have root access, try the below command and verify whether the IP assigned properly or not.

    # ifconfig

    If so, remove the IP from whm and try re add again or else use the below command to add additional IP.

    # ifconfig eth0:XXX yourIP netmask your netmask
     
Loading...

Share This Page