The Community Forums

Interact with an entire community of cPanel & WHM users!
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Net interface flap

Discussion in 'General Discussion' started by mkaleem, Aug 8, 2007.

  1. mkaleem

    mkaleem Registered

    Joined:
    Apr 13, 2007
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Aug 05 15:58:43 tsi kernel: tg3: eth0: Link is down.
    ...
    Aug 05 15:58:46 tsi kernel: tg3: eth0: Link is up at 1000 Mbps, full duplex.
    Aug 05 15:58:46 tsi kernel: tg3: eth0: Flow control is on for TX and on for RX.
    ...
    Aug 05 15:58:58 tsi kernel: tg3: eth0: Link is down.
    Aug 05 15:59:01 tsi kernel: tg3: eth0: Link is up at 1000 Mbps, full duplex.
    Aug 05 15:59:01 tsi kernel: tg3: eth0: Flow control is on for TX and on for RX.
    Aug 05 15:59:02 tsi kernel: tg3: eth0: Link is down.
    Aug 05 15:59:05 tsi kernel: tg3: eth0: Link is up at 1000 Mbps, full duplex.
    Aug 05 15:59:05 tsi kernel: tg3: eth0: Flow control is on for TX and on for RX.
    etc.

    Does any body have an idea why its getting down every time.
    I personally think that this is either the driver issue or a faulty NIC card.

    regards
    kaleem
     
  2. chirpy

    chirpy Well-Known Member

    Joined:
    Jun 15, 2002
    Messages:
    13,475
    Likes Received:
    20
    Trophy Points:
    38
    Location:
    Go on, have a guess
    I'd agree, or perhaps a fault NIC to router/switch cable or the router/switch itself.
     
Loading...

Share This Page