Please whitelist cPanel in your adblocker so that you’re able to see our version release promotions, thanks!

The Community Forums

Interact with an entire community of cPanel & WHM users!

Quicktime / Darwin Streaming

Discussion in 'General Discussion' started by tomakaze, Dec 7, 2004.

  1. tomakaze

    tomakaze Member

    Oct 12, 2004
    Likes Received:
    Trophy Points:
    Toronto, CA / Helsinki, FI
    An upgrade to accomodate Darwin is critical for cPanel to run properly along side Darwin Streaming Server, even if it is installed and configured manually manually. It is the nature of the streaming that it most often has to be delivered over port 80 to ensure it can be viewed from behind any normal firewalls, ie. lynksis, dlink, etc.

    I have gone through the process of manually tweaking httpd.conf so that
    apache and Darwin Streaming Server can live happily together on port 80.

    Port 80 streaming from Darwin bound to an specific IP address is essential for
    many installations, and even with much tweaking it is impossible to have cPanel
    live in harmony.

    Currently I have Darwin bound to a specific IP on port 80, and Apache is running
    fine, but my WHM / cPanel thinks that Apache is down, which is a major problem. I have even had to disable httpd in the chkserd Service Monitor routines, or it will be restarted every minute when it is actually working.

    Darwin Streaming Server should actually be relatively straight forward to
    integrate nicely, it is not a complicated installation, and the configuration is very consistent.

    Specific details to configure both Darwin & Apache on port 80:



    specify desired IP for streaming server:
    <PREF NAME="bind_ip_addr" >0</PREF>​



    remove "port 80" from <define SSL></defineSSL>

    add "Listen" for all IP's that need apache

    add again "Listen" for all IP's that need apache SSL
    within <define SSL></defineSSL>
    That's it!

    WHM is at this point only happy when Apache loads on every single IP bound to
    the server. Perhaps some binding control could be a feature, or automatically
    handled by the Darwin config, adding all IP's for listening to httpd.conf, but not
    the one bound to Darwin.

    I also bind the admin server to the same IP with the following:
    bind= (IP of choice)​

    Once initially added, the Darwin support could be expanded easily for more
    advanced configuration, as all streaming configuration is withing one logical
    XML file (/etc/streaming/streamingserver.xml). The admin interface could also
    be accessible.

    Please get the Apache status reading properly ASAP.
  2. kieranmullen

    kieranmullen Well-Known Member

    Aug 25, 2005
    Likes Received:
    Trophy Points:
    Portland, OR USA
    It has been a year. Has anything changed ??
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice